RACE Graphic Kit for Ultra 300/310 Yellow
USD 250.00
Viewed 382 times
Categories
Cart
Account
Search
Recent View
All Categories
×
- Boat Trailers
- Canoes
- Fishing
- Flyboard
- Foil
- Inflatable Boats
- Jet Ski
-
Kayak
- Advanced Elements Kayak
- Aire Kayak
- Airhead Kayak
- AquaGlide Kayak
- Bonafide Kayak
- Electric Kayak
- Emotion Kayak
- Field & Stream Kayak
- Future Beach Kayak
- Hobie Kayak
- Jackson Kayak
- Lifetime Kayak
- Magellan Kayak
- Native Watercraft Kayak
- Ocean Rodeo Kayak
- Old Town Kayak
- Pelican Kayak
- Perception Kayak
- Point 65 Kayak
- Seastream Kayak
- Sevylor Kayak
- Sun Dolphin Kayak
- Kite
- Outboard Motors
- Paddle Boarding
- Parts & Maintenance
- Scuba
- Trolling Motor
- Water Trampoline
- Windsurf
Shopping Cart
×
Your shopping cart is empty!
Search
×
Recent View Products
×
Product Description
RACE Graphic Kit for Ultra 300/310 Yellow
Necessary tools :
- A cutter or scissor
- A can of degreaser
- A hair dryer or heat gun (be careful of high temperatures with the gun)
- A raclette
- A soft, clean cloth
Before starting to install your kit, make sure you are in favorable conditions: in a clean and dry place, temperature around 20°C and that you have enough time. Allow 1 to 2 hours to install a kit.
Step 1: Preparing the media
Clean your fairings several times using a degreaser. It is imperative to remove all traces of glue and grease from plastics even if they are new (silicone residue) because the glue will not adhere properly. Be careful, products such as gasoline, white spirit or “WD40” type products can be effective on certain types of glue, but they are very greasy. Remember to degrease several times if you use it. Do not use window cleaners or acetone.
Step 2: Positioning and Gluing
Position the sticker to identify its location. Always start a collage with the rough presentation of the piece to be glued. Little tip: the glue used is in the form of micro beads, this means that you can affix and remove your sticker several times without it sticking permanently. Once you have chosen the appropriate location, all you have to do is scrape the sticker starting from its center which will have the effect of piercing the micro beads and thus triggering the bonding process by polymerization. Once the sticker is in place, remove air bubbles by pressing very hard outwards with a clean cloth and/or a squeegee and/or felt.
Tip: If the piece on which you are working has significant relief, consider lightly heating the sticker with a hairdryer, because under the effect of heat the vinyl will take its shape and apply more easily.
Step 3: Finishes
Finally, once the entire kit is installed, lightly warm each part using a hair dryer and apply significant pressure to the entire kit, paying particular attention to sensitive areas, always using with a soft cloth or squeegee, from the inside out.
Step 4: Imperative!
Leave your decoration kit to rest for 2-3 days, no navigation!!! After the pressure exerted, the glue must have time to polymerize and adapt to its new support.